SWASHPLATE 3143243 - Caterpillar

Illustration 38 g01689319
Illustration 39 g01689320
Use Tooling (G) in order to remove retaining ring (78).
Remove thrust washers (79) and (83), needle bearing (80), gear (81), and needle bearing (82).
Illustration 40 g01689321
Remove retaining ring (84), plate (85), friction discs (86), and clutch discs (87).
Illustration 41 g01689322
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Use Tooling (D) and a suitable press in order to compress spring (89). Use Tooling (G) in order to remove retaining ring (88). Remove retainer (90) and spring (89).
Illustration 42 g01689324
Remove ring seals (91). Release piston (92) by blowing 207 kPa (30 psi) of air into the lube passage, as shown.
Illustration 43 g01689326
Illustration 44 g01689536
Remove ring seal (93). Use Tooling (C) in order to remove bearing cone (94) and spacer (95). Remove thrust washer (97), needle bearing (98), gear (96), roller bearing (99), and thrust washer (100).
Repeat Steps 5 through Steps 7 for the remainder of the input shaft. Transmission Case
Illustration 45 g01689328
Remove bearing cup (101), bearing cup (102), bearing cup (103), bearing cup (104), and bearing cup (105) and lip seal (106) from the case.
Illustration 46 g01689331Note: Note the number of shims when you remove each of the bearing cups.
Remove bearing cup (107), bearing cup (108), bearing cup (109), and bearing cup (110) from case (16). Remove bearing cup (111) and lip seal (112) from the case (16).
Illustration 47 g01689333
Remove speed sensor (113).
Illustration 48 g01689336
Remove relief valve (114), relief valve (115), and temperature sensor (116).
Illustration 49 g01689337
Remove O-ring seals (117) from relief valve (114).
Illustration 50 g01689353
Remove O-ring seals (118) from relief valve (115).