SWEEP GP 6Y3390 - Caterpillar

6Y3390 SWEEP GP Caterpillar parts D4H, D4HTSK II

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA6Y3390
6Y-3390
6Y3390

Buy SWEEP GP 6Y3390 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK SKIDDER, TRACK-TYPE TRACTOR,

Compatible equipment models: 6Y3390:

TRACK SKIDDER D4HTSK II

TRACK-TYPE TRACTOR D4H Caterpillar

Number on catalog scheme:

Caterpillar 6Y3390 Parts scheme SWEEP GP

For full view, you need register

Information:

Place a suitable wood block between the rear axle housing and the rear main frame on both sides of the machine.Note: This will keep the axle housing from oscillating during the installation procedure.
Remove the lifting cables and Tooling (A) .
Illustration 6 g00684587
Install panel (17) and two bolts (18) .
Illustration 7 g00684516
Attach a suitable hoist and lifting slings to steps (14) , as shown. The weight of the steps is 102 kg (225 lb). Position the steps in place on the machine.
Illustration 8 g00684518
Install four bolts (16) .
Illustration 9 g00684517
Install two bolts (15) .
Illustration 10 g00684513
Install bolt (13) , the washer, and the nut.
Illustration 11 g00684511
Install two bolts (12) .
Illustration 12 g00684510
Connect tube assembly (11) to the rear oscillating axle.
Illustration 13 g00684509
Connect hose assembly (10) to the rear oscillating axle.
Illustration 14 g00684506
Place bracket (8) in position and install two bolts (7) .
Connect grease tube (9) to the rear trunnion support.
Illustration 15 g00684505
Connect tube assembly (6) for the service brake. Repeat this procedure for the opposite side.
Illustration 16 g00684504
Connect tube assembly (5) .
Illustration 17 g00684501
Put the harness in position and install three harness clips (2) and the bolts.
Connect grease tube (3) to the front trunnion support (4) .
Illustration 18 g00684498
Connect electrical connector (1) for the temperature sensor.
Fill the rear axle housing and the final drive assemblies with oil. For the correct procedure, refer to the Operation and Maintenance Manual for the machine that is being serviced.
Check the oil level of the hydraulic tank. For the correct procedure, refer to the Operation and Maintenance Manual for the machine that is being serviced.End By:
Install the rear tires and the rims. Refer to Disassembly and Assembly, "Tire and Rim (Rear) - Install" for the machine that is being serviced.
Install the rear drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Rear) - Remove and Install" for the machine that is being serviced.
Install the crankcase guard. Refer to Disassembly and Assembly, "Crankcase Guard - Remove and Install" for the machine that is being serviced.