SWING BEARING 0996317 - Caterpillar

Table 3
Linkage Seals    
Seal     Location of Seal     Part Number    
1     Arm to Work tool     7K-9206    
2     Link to Work tool     7K-9203    
3     Link to Lever     7K-9203    
6     Arm to Frame     7K-9206    
9     Lever to Arm     7K-9203    Note: Lubricate all pin bores with 5P-0960 Molybdenum Grease . Lubricate the lips of all seals with the lubricant that is being sealed.
Illustration 2 g01058320
(10) Install washers in order to minimize the gap to less than 1.2 millimeters. Use the same number of washers on each side of the arm plates. Also, use the same thickness of washers to the inner faces of the arm plates. Use the following washers:Thickness of the 203-0325 Washer ... 1 mm (.04 inch)Thickness of the 203-0327 Washer ... 2 mm (.08 inch) (11) Coat the lip seals with a thin film of 5P-0960 Molybdenum Grease .
Illustration 3 g01058336
TK370 and TK380
Illustration 4 g01058601
TK371 and TK381 (12) Install washers in order to minimize the gap to less than 1.2 millimeters. Use the same number and thickness of washers to the inner faces of both arm plates. Use the following washers:Thickness of the 203-0325 Washer ... 1 mm (.04 inch)Thickness of the 203-0327 Washer ... 2 mm (.08 inch) (13) Coat the lip seals with a thin film of 5P-0960 Molybdenum Grease .