SWITCH 0856894 - Caterpillar

Removal Procedure
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies.
Open the left access panel and turn the battery disconnect switch to the OFF position.
Illustration 1 g02534905
Disconnect harness assembly (5).
Disconnect hose assemblies (1) and (3).
Remove bolts (4) and electric motor (2). Installation Procedure
Illustration 2 g02534905
Install electric motor (2) and bolts (4).
Connect hose assemblies (3) and (1).
Connect harness assembly (5).
Turn the battery disconnect switch to the ON position and close the left access panel.