SWITCH-PUSH BUTTON 1071719 - Caterpillar

Introduction
This special instruction covers the installation procedure for 302-3209 Swing Drive Drain Lines Gp .Safety Section
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Required Parts
Table 1
302-3209 Swing Drive Drain Lines Gp Revision -00    
Item    Qty    Part No    Description    
(1)     2     7K-1181     Cable Strap    
(2)     1     282-7471     Hose As    
(3)     1     302-3210     Tee    
(4)     1     3K-0360     O-Ring Seal    
(5)     1     6V-8398     O-Ring Seal    
(6)     1     6V-9746     O-Ring Seal    
Illustration 1 g03768756
302-3209 Swing Drive Drain Lines Gp Installation Procedure
Illustration 2 g03768757
(1) 7K-1181 Cable Strap (2) 282-7471 Hose As (3) 302-3210 Tee (4) 3K-0360 O-Ring Seal (5) 6V-8398 O-Ring Seal (6) 6V-9746 O-Ring Seal
Install hose (2) onto the swing motor as shown.
Route the hose to the boom.