SWITCH AS-PRESSURE 1327748 - Caterpillar

Illustration 27 g00892997
Use Tooling (D) and a suitable lifting device to install planetary carrier (19) into gear (34) . The weight of planetary carrier (19) is approximately 48 kg (105 lb).
Illustration 28 g00892977
Install spacer (18) and gear (17) .
Illustration 29 g01389807
Note: Make sure that the oil passages in the shafts are oriented toward the center of carrier assembly (16) .
Raise the temperature of carrier assembly (16) . Lower the temperature of the shafts. Install the shafts into carrier assembly (16) until the groove of the shafts is at Dimension (A) . Dimension (A) equals 25.00 0.10 mm (0.984 0.004 inch).
Make eight stake marks at distance of Dimension (C) from each shaft. Dimension (C) equals 2.0 1.0 mm (0.08 0.04 inch). The width of each stake mark should be equal to Dimension (B) . Dimension (B) equals 4.0 1.0 mm (0.16 0.04 inch).
Illustration 30 g00892975
Install carrier assembly (16) .
Illustration 31 g00892968
Install retaining ring (15) .
Illustration 32 g00892965
Install washer (14) and bearing assembly (13) . Install gear (12) and washer (11) . Use Tooling (C) to install retaining ring (10) .
Repeat Step 50 for the other two planetary gears.
Illustration 33 g00780428
Install spacer (9) and gear (8) .
Illustration 34 g00892906
Install O-ring seals (7) on plugs (5) .
Illustration 35 g00892888
Install plugs (5) in cover (2) . Tighten plugs (5) to a torque of 80 10 N m (59 7 lb ft). Install spacer (6) in cover (2) . Position gear (4) and install bolts (3) .
Place a piece of solder in the center of gear (8) .Note: You may need to apply some grease to the solder in order to keep the solder in position on gear (8) .
Illustration 36 g00892883
Use Tooling (B) and a suitable lifting device to Install cover (2) . The weight of cover (2) is approximately 32 kg (70 lb).
Illustration 37 g00892878
Install four bolts (1) at 90 degrees from each other.
Remove bolts (1) .
Use Tooling (B) and a suitable lifting device to remove cover (2) . The weight of cover (2) is approximately 32 kg (70 lb).
Use a micrometer to measure the thickness of the solder. Record this measurement in order to determine the thickness of the shims for plate (6) . Adjust the shims in order to obtain a clearance of 1.000 + 1.000 mm (0.0394 + 0.0394 inch) between plate (6) and gear (8) .
Apply Tooling (S) to the mating surfaces of cover (2) and the housing.
Use Tooling (B) and a suitable lifting device to Install cover (2) . The weight of cover (2) is approximately 32 kg (70 lb).
Install bolts (1) and the washers. Tighten bolts (1) to a torque of 900 100 N m (664 74 lb ft).
Illustration 38 g01151095
Remove plug (5) (not shown). Attach Tooling (T) to cover (2) . Reduce the air pressure at the source to 103 kPa (15 psi). Apply air pressure to Tooling (T) . This air will test the Duo-Cone seals.
Use the ball valve on Tooling (T) to eliminate the air pressure to the final drive. A pressure of 98