SWITCH AS 1352364 - Caterpillar

Illustration 1 g06098269
Typical example
Table 1
Specification for 340-8250 Front Idler Gp, 340-8249 Front Idler Gp, and 512-2668 Front Idler Gp
Item Qty Part Specification Description
1 1 9W-2146 Plug Before assembly, apply blue Loctite 243 to the threads.
Torque to 22 3 N m (195 27 lb in).
2 2 - The rubber toric seals and all the contacting surfaces must be clean and dry at assembly. Before assembly, apply a thin film of 6V-4876 Lubricant to the contacting surfaces of two metal seal rings. The metal seal rings must be assembled square. The rubber toric seal should not bulge and the rubber toric seal should not twist.
3 - - Install the idler shaft so that the identification mark "R" and the milled surface as shown.
4 - - Before assembly, the surfaces must be clean and free from protective coating.
5 2 6Y-7599 Idler Bearing Bore after assembly is 115.31 0.09 mm (4.540 0.004 inch).
6 2 194-1162 Dowel Install dowel with thread side facing plug.
7 2 102-0883 Pipe Plug Before assembly, apply purple Loctite Hi-Temp Flange Sealant to the threads.
Torque to 22 3 N m (195 27 lb in).
- - - Minimum end play is 0.41 mm (0.016 inch).
Maximum end play is 1.82 mm (0.072 inch).
Illustration 2 g06098271
Table 2
Item Qty Part Specification Description
8 4 - Torque to 540 71 N m (398 52 lb ft).