SWITCH AS-ROCKER 1384894 - Caterpillar

Refer to Service Manual module, SENR4705 ... Automatic Ether Injection System, for detailed instructions and explanations.Operation
Refer to the flowchart on the reverse side of this card for the operation of the Ether System. The AEIS might be injecting ether without any of it reaching the engine due to clogged or leaky ether passages. Use "Plumbing Check" procedure in Service Manual to check for leaks/blocks in the plumbing.Fault Codes
Refer to the service manual for a detailed description of the fault codes displayed on the seven segment display on the front of the control box.Warning Lamps/Horn Operation
Ether Cylinder Replacement Procedure
The AEIS is a timer based system, and so it is extremely important that the following steps are strictly followed when replacing ether cylinders.1. Disconnect switch should be ON and the Key Switch should be OFF.2. Loosen cylinder clamp and unscrew empty 7X1062 Ether Cylinder.3. Replace 9X7138 Brass Filter and O-ring in the solenoid assembly collar with the new one supplied with each cylinder.4. Put the supplied 9X0147 Dust Collar on the new ether cylinder.5. Hand tighten the new ether cylinder in place of the old one.6. Tighten clamp to secure the cylinder. Verify there are no ether leaks.7. Turn key switch to ON position and verify that the particular ether out warning lamp is off now.