SWITCH AS 1460795 - Caterpillar

Basic Operation
Illustration 1 g01789440
Profile guidance enables you to excavate a pre-defined profile section with an unlimited number of reach and elevation points, as shown in Illustration 1.Profile mode does not support cab rotation.Selecting A Profile
Profile elements are stored in profile memory. This memory is only accessible when the Profile vertical guidance method has been selected.Selecting A Profile From Memory
Refer to the following steps in order to select a Profile from memory.
Illustration 2 g01789436
From any guidance screen, press "Profile".The "Select Profile" dialog appears.
Select a profile. The guidance screen re-appears, and the Bench Required flashing warning message is displayed.Creating And Selecting A New Profile
From any guidance screen, press "Profile".The Select Profile dialog appears.
Illustration 3 g01789437
Press "Create New".The "Profile Definition" dialog appears, with the point of origin of the profile displayed as a green point.
Illustration 4 g01789438
Use any of the following tools to create the new profile:
Press Use Bucket in order to align the current position of the bucket focus to the origin of the profile. You are asked to move the bucket so that the bucket focus is at the origin of the profile you are creating. Then you are asked to press the "OK" key. Cross hairs appear in the Profile Definition dialog's design pane. This is an indication of the current position of the bucket that is relative to the origin. The "Use Bucket" softkey is replaced with the "Point Here" softkey.
When you have aligned the bucket focus with the origin, you can press "Point Here" soft key at any time in order to add a line segment to the profile. A new point appears in the "Profile Definition" dialog's design pane at the current position of the bucket focus.The new point defines a new line segment. The new point and the new line segment are displayed in red, indicating that the point has edit focus.
Press "New Point" at any time in order to add a line segment to the profile. A new point appears in the "Profile Definition" dialog's design pane. The new point defines a new, horizontal, line segment 0.5 m (18 inches) long. Both the new point and the new line segment are displayed in red, indicating that the point has edit focus.
Press the arrow keys on the control box at any time in order to modify the position of the selected point.
Press the forwards and backwards softkeys to move the edit focus forwards and backwards along the profile.
Press "Delete Point" in order to delete the point with edit focus.
Illustration 5 g01789439
When you have finished adding segments to the profile, press the "OK" key in order to save the profile.The "Profile Name" dialog appears.
Press "OK" in order to accept the name that is supplied.The name that is supplied can be edited. Use the arrow keys in order to make any changes. Presst the "OK" key in order to accept any changes.The "Select Profile" dialog appears with the name of the new profile highlighted in the profile list.
Press the "OK" key in order to select the profile.The guidance screen appears. The