SWITCH AS-ROCKER 1552703 - Caterpillar

Illustration 1 g00778381
(A) Boom cylinder (B) Stick cylinder (C) StickNote: All bores must be free of paint. Coat all bores for pins with lubricant.Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward. (1) Two 180-7576 Sleeve Bearings Outside diameter ... 116.115 0.011 mm (4.5714 0.0004 inch) Inside diameter ... 100.29 0.02 mm (3.948 0.001 inch) Installation depth for the sleeve bearing in the bearing bore ... 9.5 0.8 mm (0.37 0.03 inch) (2) Lubricate the sealing lip slightly with the lubricant that is being sealed. (3) 180-7752 Pin Diameter after plating ... 89.850 0.025 mm (3.5374 0.0010 inch) Plating thickness for the first layer ... 0.015 mm (0.0006 inch) Plating thickness for the second layer ... 0.015 mm (0.0006 inch) Bore diameter for pin ... 80.037 0.037 mm (3.1511 0.0015 inch) (4) 4I-4809 Pin Assembly Diameter after plating ... 79.850 0.025 mm (3.1437 0.0010 inch) Minimum thickness for plating ... 0.005 mm (0.0002 inch) Bore diameter for pin ... 80.0 mm (3.15 inch) (5) 102-3196 Pin Diameter after plating ... 89.850 0.025 mm (3.5374 0.0010 inch) Minimum thickness for plating ... 0.005 mm (0.0002 inch) Bore diameter for pin ... 90.043 0.043 mm (3.5450 0.0017 inch) (6) Use the necessary shims to adjust the lateral clearance. Place 166-1487 Shim next to the stick. Maximum clearance ... 0.8 mm (0.03 inch) 113-2127 Shim ... 0.5 mm (0.02 inch) 093-0116 Shim ... 2.0 mm (0.08 inch) 166-1487 Shim ... 2.0 mm (0.08 inch)