SWITCH AS 1571357 - Caterpillar

Illustration 2 g00872046
Install bolts (24) in order to attach compressor assembly (25) to scissor assembly (11).
Illustration 3 g00872043
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install bolt (23) in order to attach spring assembly (18) to scissor assembly (11). Attach hose assembly (22) to spring assembly (18).
Illustration 4 g00872037
Install shaft (20) in order to attach toggle assembly (21) to scissor assembly (11). Tighten the two nuts for shaft (20) to a torque of 15 3 N m (11 2 lb ft).
Illustration 5 g00872031
Install shaft assemblies (19) in order to attach tether straps (11A) and scissor assembly (11) to housing assembly (14). Tighten the nuts on shaft assemblies (19) to a torque of 20 5 N m (15 4 lb ft). Install blocking in order to prevent scissor assembly (11) from falling.
Illustration 6 g00872029
Illustration 7 g00872020
Install screw (17) in order to attach housing assembly (14) to spring assembly (18).
Install shaft (15) in order to attach toggle assembly (16) to scissor assembly (11). Tighten the two nuts for shaft (15) to a torque of 15 3 N m (11 2 lb ft).
Illustration 8 g00897454
Illustration 9 g00872007
Install bearings (12B) to shock absorber (13).
Install bolts (12) in order to attach shock absorber (13) to scissor assembly (11) and housing assembly (14). Remove the blocking. Note: Illustration 8 shows the location of lockwasher (12A), bearings (12B), washers (12C), nut (12D), and locknut (12E).
Repeat Steps 8 and 9 if the seat is equipped with a shock absorber on the opposite side.
Illustration 10 g00871994
Connect harness assemblies (9) and hose assembly (10) to air valve (8).
Illustration 11 g00871971
Position air valve (8) to upper housing assembly (7). Position upper housing assembly (7) to the seat.
Illustration 12 g00871951
Install cable strap (6) in order to secure harness assemblies (9) to upper housing assembly (7).
Illustration 13 g00876043
Install shaft assemblies (5). Tighten the nuts for shaft assemblies (5) to a torque of 20 5 N m (15 4 lb ft).
Position plate (4) to the seat. Install lockwasher (3A) and nut (3) in order to secure air valve (8) to the seat. Tighten the setscrew in adjustment knob (1) in order to secure adjustment knob (1) to air valve (8).
Illustration 14 g00871915
Install boot (2) to the seat.