SWITCH AS-ROCKER 1735479 - Caterpillar

"PLM Commands"
Illustration 2 g01362129
"PLM Commands" Menu for Cat ET
There are ten commands that can be completed by selecting "Service/PLM Commands" from the menu bar in Cat ET.Registration - This command automatically queues a registration message and an administration message. The registration message will queue up and wait for the next available satellite to complete the process. The parameters "Queued Registration Messages"and "Queued Administration Messages" in "Message Queue" will show a value of "1". When the registration message and administration messages has been successfully transmitted, the value will change back to "0". This registration process can take from 15 minutes to 1 hour. The time frame is dependent on the performance of the communications network.Note: Performing the registration process will activate the installed system. Complete the configuration process prior to performing the registration process.Note: In order to register Product Link, the Product Link antenna must have a clear view of the sky for detecting satellites. Therefore, if the machine is inside of a building or another structure that would prevent a clear view of the sky, the machine will need to be moved outside. The yellow LED and the orange LED on the PL121SR radio should be solid in order to ensure that a lock has been established with the satellite. If the LED indicators for the radio cannot be observed, then the user can look in Cat ET at "Satellite Information" and "Satellite Communication Status" in order to determine that satellite communication has been established.De-registration - This command de-registers the Product Link before removing the unit for installation on another machine. This command will set all of the fields back to the default values. This command will clear the memory of the unit. All of the Fence settings and diagnostics in the memory are erased. After the message is "queued", the message should enter the Message Queue. This message can be viewed by observing "Message Queue" for the Product Link ECM. After the message has been transmitted, the unit can be removed. The unit can be reinstalled on another machine.Status