SWITCH GP-MAGNETIC 1752302 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 5P-3525 Piston Ring Compressor 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Turn the crankshaft until the bearing journals are at the bottom center position.
Apply clean engine oil on the crankshaft journals and on the inside of the cylinder liners. Apply clean engine oil on the piston rings and the connecting rod bearings.
Position the piston ring gaps at 120 degrees away from each other.
Illustration 1 g01957866Note: Use the cylinder liner as a guide when you install Tooling (A).
Use Tooling (A) to install piston (3) and the connecting rod. Ensure that the Mark "V" on the piston is in alignment with the Mark "V" on the cylinder block.
Push the piston and the connecting rod into position over the crankshaft.
Illustration 2 g01957865
Illustration 3 g00990450
Apply clean engine oil on the bearings, the bolt threads and the nuts that make contact with the connecting rod caps. Place connecting rod cap (2) in position on the connecting rod and install nuts (1). Tighten the nuts to a torque of 41 4 N m (30 3 lb ft). Place a mark on each nut and the end of each bolt. Turn each nut for an additional 90 degrees. Note: When you install the connecting rod caps ensure that the number on the side of the cap matches the number on the side of the connecting rod.
Repeat Steps 1 through 6 for the remaining pistons. End By:
Install the engine oil pump.
Install the cylinder head.