2105429 SWITCH AR-AUTOMATIC TRANSFER Caterpillar parts
ATS
Rating:
Alternative (cross code) number:
CA2105429
210-5429
2105429
CA2105429
210-5429
2105429
AUTOMATIC TRANS SWITCH,
Compatible equipment models: 2105429:
For full view, you need register
Information:
Installation Procedure
Make sure that the mating surfaces of the swing motor and the swing drive are thoroughly clean and dry.
Replace the O-ring seal that is used between the swing motor and the swing drive with a new O-ring seal. Replace the O-ring seals that are used in the ends of all the hose assemblies with new O-ring seals.
Install the O-ring seal on the swing motor. Put clean oil on the O-ring seal.
Illustration 1 g00360998
Fasten a suitable lifting device to the swing motor. The weight of the swing motor is 34 kg (75 lb). Put the swing motor in the motor's original position on the swing drive. Install twelve bolts (10) and the washers that hold the swing motor. Apply 9S-3263 Thread Lock Compound to the bolts. Tighten the bolts to a torque of 90 1 N m (65 1 lb ft).
Illustration 2 g00360994
Install hose assembly (8) to the swing parking brake.
Install clamp (9) to the swing parking brake.
Connect the electrical connector to the swing parking brake.
Install hose assembly (5) to the swing motor.
Illustration 3 g00360993
Install three hose assemblies (2), (3) and (4) to the swing motor.
Illustration 4 g00360992
Install four hose assemblies (1) to the main control valve.
To avoid system damage, make sure that the hydraulic motor is properly filled with hydraulic oil before start-up.
Note: Refer to Operation and Maintenance Manual, "Lubricant Viscosities and Refill Capacities"for the proper filling procedure and the proper levels for the hydraulic oil system.
Fill the swing drive with oil to the correct level.
Make sure that the mating surfaces of the swing motor and the swing drive are thoroughly clean and dry.
Replace the O-ring seal that is used between the swing motor and the swing drive with a new O-ring seal. Replace the O-ring seals that are used in the ends of all the hose assemblies with new O-ring seals.
Install the O-ring seal on the swing motor. Put clean oil on the O-ring seal.
Illustration 1 g00360998
Fasten a suitable lifting device to the swing motor. The weight of the swing motor is 34 kg (75 lb). Put the swing motor in the motor's original position on the swing drive. Install twelve bolts (10) and the washers that hold the swing motor. Apply 9S-3263 Thread Lock Compound to the bolts. Tighten the bolts to a torque of 90 1 N m (65 1 lb ft).
Illustration 2 g00360994
Install hose assembly (8) to the swing parking brake.
Install clamp (9) to the swing parking brake.
Connect the electrical connector to the swing parking brake.
Install hose assembly (5) to the swing motor.
Illustration 3 g00360993
Install three hose assemblies (2), (3) and (4) to the swing motor.
Illustration 4 g00360992
Install four hose assemblies (1) to the main control valve.
To avoid system damage, make sure that the hydraulic motor is properly filled with hydraulic oil before start-up.
Note: Refer to Operation and Maintenance Manual, "Lubricant Viscosities and Refill Capacities"for the proper filling procedure and the proper levels for the hydraulic oil system.
Fill the swing drive with oil to the correct level.