SWITCH AS-ROCKER 2320314 - Caterpillar

Illustration 10 g06160825
Use vibratory frequency switch (15) to set the vibratory system in the low frequency/high amplitude mode.Note: Two things indicate when the vibratory system is in the low frequency/high amplitude mode. First, "Vibe Frequency Mode Low" will appear on the display. Second, one LED next to vibratory frequency switch (15) will be illuminated.
Illustration 11 g06160826
If necessary, use drum select switch (16) to select both drums.Note: Two things indicate when the machine is in dual drum mode. First, "Vibe Drum Select Dual" will appear on the display. Second, both the LEDs next to drum select switch (16) will be illuminated.
Set the vibratory system in the manual mode.
Illustration 12 g06148594
Select "Main Menu" (17) on the machine display.
Select "Machine Setup" (18).
Illustration 13 g06148596
Select "Vibe Turn On Speed" (19).
Illustration 14 g06148599
Select "Manual" mode (20).
Launch the Plus+1TM program on the computer to enable the vibe test mode.Note: First-time users need to perform the tasks in the Communication and Connections Wizard. This wizard allows the Windows® operating system to recognize the USB device. Follow the on-screen instructions.
Illustration 15 g06153168
Click "Status" icon (21).
Check for "Active Codes". Clear any open "Active Codes".
Click "Machine Control" (22).
Illustration 16 g06153171
Click "Hydraulics" (23).
Click "Vibe Test Modes" (24).
Illustration 17 g06163464
Click "Enable" icon (25) to enable the "Normal Vibe Test Mode".
When "Normal Vibe Test Mode" is in "Enabled" mode, the Plus+1TM program is launched.
Illustration 18 g06163659
Standard propel control lever
Illustration 19 g06163663
Optional propel control lever
Press vibratory control switch (26) on the propel lever. The vibratory control switch must be held in the ON position for at least 2 seconds for the vibratory system to actuate.
Read flow on Tool (B). The flow should be approximately 3.5 L/min (0.9 US gpm) to 9 L/min (2.4 US gpm).Note: Motor case drain flow cannot be adjusted. If the case drain flow is greater than 9 L/min (2.4 US gpm), determine the source of excess flow and repair. If the flow is less than 3.5 L/min (0.9 US gpm), inspect the flushing valve and orifices.
Use vibratory control switch (26) to stop the vibratory system.
Use vibratory frequency switch (15) to place the drums in the high frequency/low amplitude mode.Note: Two things indicate when the vibratory system is in the high frequency/low amplitude mode. First, "Vibe Frequency Mode High" will appear on the display. Second, two of the LEDs next to vibratory frequency switch (15) will be illuminated.
Press vibratory control switch (26) on the propel lever. The vibratory control switch must be held in the ON position for at least 2 seconds for the vibratory system to actuate.
Read flow on Tool (B). The flow should be less than 3.5 L/min (0.9 US gpm) to 9 L/min (2.4 US gpm).Note: Motor case drain flow cannot be adjusted. If the case drain flow is greater than 9 L/min (2.4 US gpm), determine the source of excess flow and repair. If the flow is less than 3.5 L/min (0.9 US gpm), inspect the flushing valve and orifices.
Use vibratory control switch (26) to stop the vibratory system.
Move parking brake switch (2) to the ON position.
Place the engine in ECO mode or in low