SWITCH AS-ROCKER 2382212 - Caterpillar

that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments, the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: calendar time, fuel consumption, mileage and service hours . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Storage Procedure - Check
Fuel System - Prime
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Water Separator - Check/Drain
Power Take-Off Clutch - Check
Walk-Around Inspection
Every Week
Jacket Water Heater - Check
Every 250 Service Hours
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil and Filter - Change
Fuel Tank Water and Sediment - Drain
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 500 Service Hours or 6 Months
Engine Protective Devices - Check
Every 2000 Service Hours
Alternator - Inspect
Every Year
Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours or 3 Years
Coolant (DEAC) - Change
Coolant Extender (ELC) - Add
Coolant Temperature Regulator - Replace
Every 8000 Service Hours or 3 Years
Driven Equipment - Check
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change
Every 14 400 L (3750 US gal) of Fuel or 250 Service Hours or 1 Year
Battery Electrolyte Level - Check
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Fuel System Primary Filter - Replace
Fuel System Secondary Filter - Replace
Grounding Stud - Inspect/Clean/Tighten
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Every 114 000 L (30 000 US gal) of Fuel or 3000 Service Hours
Aftercooler Core - Clean/Test
Every 170 400 L (45 000 US gal) of Fuel or 3000 Service Hours
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Mounts - Inspect
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Fan Drive Bearing - Lubricate
Fuel Injector - Check
Every 380 000 L (100 000 US gal) of Fuel or 10 000 Service Hours
Overhaul Considerations
Overhaul
Fan Drive Bearing - Replace