SWITCH AS-ROCKER 2514340 - Caterpillar

Removal Procedure
Start By:
Remove the front tires and rims.
Table 1
Required Tooling
Tool Part Number Part Description Qty
A 1P-2320 Combination Puller 1
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g06207413
Use Tooling (A) to remove nut (1).
Remove tie rod (2).
Repeat for opposite side.Installation Procedure
Install tie rod (2) in the reverse order of removal.
Tighten tie rod (2) to a torque of 250 5 N m (184 4 lb ft).
Tighten nut (1) to a torque of 220 5 N m (162 4 lb ft).