SWITCH-PRESSURE 2926568 - Caterpillar

Introduction
This special instruction gives the correct procedure to install the following components:
A new bevel gear on a new differential housing
An old bevel gear on a new differential housing
A new bevel gear on an old differential housingImportant Safety Information
Do not perform any procedure in this special instruction until you have read this special instruction and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures can result in personal injury. The following procedures should also be observed.Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard.Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. If the tools, the procedure, the work method, or your actions are not recommended by Caterpillar, ensure that the tools and your actions are safe for you and for others.Ensure that the product will not be damaged or the product will be made unsafe by the operation, lubrication, maintenance, or the repair procedures.Procedure To Install A New Bevel Gear or an Old Bevel Gear on a New Differential Housing
Illustration 1 g02968078
Illustration 2 g02968858
Place bevel gear (1) in position on differential housing (2) with the bolt holes in alignment. Use clamps to hold the bevel gear in this position.
Use a reamer to make one hole through the differential housing 19.050 0.013 mm (0.7500 0.0005 inch).
Install one of