SWITCH AS-MULTIFUNCTION 2999241 - Caterpillar

Illustration 1 g00386930
Schematic for the Position Sensor (Tilt Lever)The possible causes for this diagnostic code are listed:
The tilt lever sensor rotated below the normal operating range.
The signal circuit is shorted to ground.System Response:The machine response is listed:
The bucket will not tilt back.
After the diagnostic code is cleared, the tilt lever must be recentered in order to allow the tilt linkage to operate.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code is corrected. Note: Ensure that the diagnostic code is active and that the diagnostic code indicator is active.Test Step 1. CHECK THE HARNESS.
Turn the key start switch to the OFF position.
Disconnect the harness from the sensor.
Turn the key start switch to the ON position.
At the harness connector for the sensor, measure the voltage from the ECM between contact B (wire 299-BK) and contact C (wire H711-GN).Expected Result:The voltage should be 5 0.5 DCV.Results:
YES - The voltage measures 5 0.5 DCV.Repair: The harness is correct. The sensor or the sensor harness has failed. Check the sensor harness. If no defect is found, replace the sensor. Stop.
NO - The voltage does not measure 5 0.5 DCV. The ECM or the harness has failed. Proceed to test step 2.Test Step 2. CHECK THE GROUND CIRCUIT OF THE HARNESS.
The sensor remains disconnected.
Turn the disconnect switch to the OFF position.
Turn the key start switch to the OFF position.
Disconnect the harness from the ECM.
At the harness connector for the sensor, measure the resistance between contact B (wire 299-BK) and the frame ground.Expected Result:The resistance should be less than 5 Ohms.Results:
YES - The resistance is less than 5 Ohms. The harness is correct. Proceed to test step 3.
NO - The resistance is greater than 5 Ohms.Repair: The ground circuit in the harness has failed. There is an open circuit between contact B (wire 299-BK) and the frame ground. Repair the harness or replace the harness. Stop.Test Step 3. CHECK FOR A SHORTED HARNESS.
The sensor and the ECM remain disconnected from the harness.
The disconnect switch remains in the OFF position.
At the harness connector for the sensor, measure the resistance between contact C (wire H711-GN) and contact A (wire 146-GY).Expected Result:The resistance should be greater than 5000 Ohms.Results:
YES - The resistance is greater than 5000 Ohms. The harness circuit is correct. Proceed to test step 4.
NO - The resistance is less than 5000 Ohms.Repair: The harness has failed. There is a short between wire (H711-GN) and wire (146-GY). Repair the harness or replace the harness. Stop.Test Step 4. CHECK FOR A OPEN HARNESS.
The sensor and the ECM remain disconnected from the harness.
The disconnect switch remains in the OFF position.
Check the continuity between connector J2-4 (wire H711-GN) and contact C (wire H711-GN) for the sensor.Expected Result:There is continuity.Results:
YES - There is continuity.Repair: The signal circuit is correct. Ensure that the diagnostic code is still active. If the diagnostic code is active, it is unlikely that the ECM has failed. Exit