SWITCH AS-DISCONNECT 3694098 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect" for the machine that is being serviced.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: The following procedure is for removal of the input assembly. The input assembly may also be referred to as the pinion assembly.Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Drain the oil from the winch. The capacity of the winch is 24.5 L (6.5 US gal). Refer to the Operation and Maintenance Manual, SEBU7353, "Winch Oil - Change" for the proper procedure.
Illustration 1 g00696822
Remove three bolts (1) and the washers from panel (2) .
Remove two bolts (3) (hidden), the washers, and panel (2) from the machine.
Illustration 2 g00696828
Remove four bolts (4) and two straps (6) .
Separate winch drive shaft (5) from the winch.
Illustration 3 g00696829
Remove six bolts (7) and the washers from input assembly (8) .
Remove input assembly (8) and shim pack (9) from the machine.