SWITCH-SOLENOID 3860559 - Caterpillar

Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Parameter Worksheet    
"Rating Number"        
"Rated Power"        
"Rated Peak Torque"        
"Top Engine Speed Range"        
"Test Spec"        
"Equipment ID"        
"Engine Serial Number"        
"ECM Serial Number"        
"Personality Module Part Number"        
"Personality Module Release Date"        
"Personality Module Description"        
"Total Tattletale"        
"Engine Location"        
"Fuel To Air Ratio Mode"        
"Low Idle Speed"        
"Maximum Trolling Engine Speed"        
"Transmission Oil Temperature High Set Point"        
"Transmission Oil Pressure High Set Point"        
"Transmission Oil Temperature Sensor"        
"Transmission Oil Pressure Sensor"        
"Fuel Correction Factor"        
"FLS" (Full Load Setting)        
"FTS" (Full Torque Setting)        
"Engine Monitoring Mode"        
"Coolant Level Sensor"        
"Maintenance Indicator Mode"        
"PM1 Interval"        
Engine Oil Capacity        
"Customer Password #1"        
"Customer Password #2"        
"6 Cylinder Cutout"        
Information from Engine Information Plate    
"Engine Serial Number"        
"FLS"        
"FTS"        Note: Compare the FLS and the FTS from the ECM with the values that are listed on the Engine Information Plate. The FLS and the FTS should only be changed because of a mechanical change in the engine. The use of the wrong parameters could cause damage to the engine.