SWITCH 5012174 - Caterpillar

Illustration 1 g06213592 (1) MONITOR DISPLAY - Displays the weight of material currently in the bucket. (2) BUCKET WEIGHT - Displays the weight of material currently in the bucket. (3) BUCKET ZERO - Zeros the current bucket weight. (4) BUTTON - Button to activate Bucket Zero (3).Weigh Range
The weigh range is the segment of the lift cycle, during which data is collected to calculate a weight. The weigh range settings can be adjusted through Cat® Electronic Technician (Cat ET) or the monitor display.Following are the weigh range considerations:
The bottom of the weigh range can be set from a minimum of 35% to a maximum of 65%
The top of the weigh range should end at least 10% lower than the maximum lift height
The total size of the weigh range, bottom to top, must be at least 15%
The default setting for the weigh range is from 50% to 65% of the liftBUCKET WEIGHT
SCALED WEIGHT - Displayed above bucket icon (2) on the main screen of monitor display (1). Occurs after lifting through weigh range smoothly with bucket in fully racked position.Low Lift Weigh
Low lift weigh is used when a scaled weight is not achievable. While issuing a slow and smooth lift command, the system monitors the calculated payload. Once the payload signal has stabilized a weight will be shown, if the linkage is above 35% of full lift travel. Since this weight is calculated while the linkage is moving, the weight is:
More closely correlated to the calibration
Not as accurate as a scaled weightAuto-Store
The Auto-Store feature will automatically store data every 25 passes if the payload information is not stored or cleared. The stored passes will remain on the screen until a key cycle is performed.Overload Warnings
The overload warning feature notifies the operator when a payload measurement exceeds 116.5% of the Loader Bucket Payload Target Weight configured in Cat ET . The feature can be enabled/disabled through Cat ET as well, and is disabled by default. If a calculated weight is overloaded, and the machine has gone to reverse since digging, the operator will be notified via a pop-up. The system monitors for overload both in normal operating mode and in standby mode.