SWITCH AS-ROCKER 5092819 - Caterpillar

Table 1
Event Codes    
Code and Description    Conditions which Generate this Code    System Response    
190-15
Engine Speed : High - least severe (1)     The engine rpm has exceeded the trip point for engine overspeed for the delay time.     The code is logged. The ECM may shut down the engine.    
190-16
Engine Speed : High - moderate severity (2)    
190-0
Engine Speed : High - most severe (3)    
E362(1)
Engine Overspeed - least severe     The engine rpm has exceeded the trip point for engine overspeed for the delay time.     The code is logged. The ECM may shut down the engine.    
E362(2)
Engine Overspeed - moderate severity    
E362(3)
Engine Overspeed - most severe    Probable Causes
Turbocharger
Intake air and starting aids
Drop of loadRecommended Actions
Note: The procedures have been listed in order of probability. Complete the procedures in the order of the listed test steps.
Table 2
Troubleshooting Test Steps    Values    Results    
1. Proper Operation of the Turbocharger
A. Check for proper operation of the turbocharger.
B. Check for any oil that may be leaking into the air inlet.
   
Turbocharger
   
Result: The turbocharger is leaking oil into the inlet.
Repair: Repair or replace the turbocharger.
Verify that the repair eliminated the problem.
Result: The turbocharger is not leaking oil into the inlet.
Proceed to Test Step 2.
   
2. Intake Air
A. Check for combustible gases in the surrounding atmosphere.
B. Check for proper operation of starting aids (if equipped).
   
Air quality
   
Result: The atmosphere has combustible gases.
Repair: Do not operate the engine in an environment with combustible gases.
Verify that the repair eliminated the problem.
Result: The atmosphere does not have combustible gases.
Proceed to Test Step 4.
   
3. Check for a Sudden Drop of Engine Load
A. Converse with the operator about the overspeed event.
   
Engine load
   
Result: The operator confirms that the overspeed was caused by a sudden drop of engine load.
Repair: Decrease the load on the engine gradually.
Verify that the repair eliminated the problem.
   If the procedure did not correct the issue, contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).