SWITCH A 7G5741 - Caterpillar

Illustration 50 g03236616
Clip the hose assembly to the tube assembly as shown in Illustration 50. Use one clip (159), one clip (54), one bolt (156), two washers (14), and one nut (15) at both locations.
Illustration 51 g03236716
Use one clip (42), one clip (44), one clip (54) to secure the 365-1707 Hose As, the 371-8907 Hose As, and the 302-7452 Hose As. Use one bolt (156), two washers (87), and one nut (88) to attach the three hose assemblies.
Illustration 52 g03267837
Use one coupling assembly (162), one coupling assembly (163), and hose (46) to manufacture the 381-6454 Hose As (173). Attach the 90 degree bend of the hose assembly to port (5) on the 371-4192 Brake Valve and Mounting Gp. Route the hose assembly across the machine as shown Illustration 52. Attach the 45 degree bend of the hose assembly to the brake release pump and motor group.
Use one coupling assembly (157), one coupling assembly (164), and hose (45) to manufacture the 381-6453 Hose As (178). Attach the 90 degree bend of the hose assembly to port (11) on the 371-4192 Brake Valve and Mounting Gp.
Remove the top bolt and washer from the bracket. Use the bolt and washer to attach bracket (113) to the machine.
Install tee (84), nut (73), and three O-ring seals (125) to bracket (113). Install cap (74) to the opening on the tee that points toward the center of the machine. Install the straight end of hose assembly (178) to the top connection on the tee.
Use one coupling assembly (157), one coupling assembly (162), and hose (47) to manufacture the 381-9006 Hose As (177). Attach the 45 degree end of the hose to the bottom connection on tee (84). Remove the cover from connector that was installed in Step 48. Attach the straight end of the hose assembly to the connector.
Illustration 53 g03245256
Hose assembly (173) attaches to hose assemblies (174), (175), and (176). Go to where hose assembly (173) and hose assembly (174) cross. Install one grommet (62) on hose assembly (174). Place one clip (58), and one clip (59) around the grommet.
Install one grommet (55) on hose assembly (173) and hose assembly (178). Place one clip (49), and one clip (50) around each grommet. Use one bolt (93), two hard washers (95), and one nut (96) to fasten the clips together.
Place one grommet (105) around the sleeve at the end of hose assembly (175) and (176). Place one clip (66) and one clip (67) around the grommets.
Place one grommet (55) around hose assembly (173) near hose assembly (175) and (176). Place one clip (49) and one clip (50) around the grommets. Use one bolt (93), two hard washers (95), and one nut (96) to fasten the clips.
Place one clip (43) around hose (118) near plate assembly (145). Place one grommet (55) around hose assembly (173) near plate assembly (145). Place one clip (49) and one clip (50) around the grommet. Place one spacer (81) over the top hole in plate assembly (145). Align the holes in clips with the