SWITCH AS-MAGNETIC 7X6402 - Caterpillar

Install Tooling (B) on pin (10) .
Use Tooling (B) in order to remove pin (10) .
Use the hoist in order to remove lift cylinder (6) . The weight of lift cylinder is approximately 250 kg (550 lb). Disassembly and Assembly Information
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
C     127-4904     Repair Stand     1    
D     7M-7456     Bearing Mount Compound     1    
E     1P-1833     Adapter     1    
4C-9633 Puller Stud     1    
1A-1935 Full Nut     1    
6V-3160 Double Acting Cylinder     1    
9S-5565 Pin Puller Sleeve As     1    
3S-6224 Electric Hydraulic Pump Gp     1    
F     1P-0808     Multipurpose Grease     1    
G     1P-0510     Driver Gp     1    
H     9U-7868     Spanner Wrench     1    
127-8064 Adjustable Plate     1    
J     195-4609     Seal Pick     1    
Illustration 9 g01275552
The callouts in this graphic reference each of the following steps. (1) Apply Tooling (D) to the seal groove prior to assembling the wiper seal. (2) Lubricate sealing lips with a thin covering of the lubricant that is being sealed. (3) Use a 46 mm socket to remove the nut.Note: Apply Tooling (F) to the threads.Note: Tighten nut (3) to a torque of 4500 450 N m (3320 330 lb ft).The bottom face includes both ends of the articulation cylinders. Install the bearings to Depth (X) from the bottom face. Dimension (X) ... 7.14 0.25 mm (0.281 0.010 inch)Note: Do not use an impact type driver to install the bearings.Installation Procedure
Note: Lubricate the bores and the pins with 5P-0960 Molybdenum Grease prior to installation.
Illustration 10 g00952744
Attach a suitable hoist and lifting slings to lift cylinder (6) .
Use the hoist in order to install the lift cylinder. The weight of the lift cylinder is 250 kg (550 lb).
Install pin (10) .
Install the washer, the spacer and bolt (9) that holds pin (10) .
Install grease fitting (11) in pin (10) .
Install pin (8) .
Install the washer, the spacer and bolt (7) that holds pin (8) .
Illustration 11 g00350676
Use two persons in order to install front fender (4) . The weight of front fender (4) is 34 kg (75 lb).
Install nuts (5) .
Illustration 12 g00350675
Connect hydraulic hose assemblies (3) to the lift cylinder.
Illustration 13 g00350674
Install front guard (2) and nuts (1) .
Fill the pin bores of the lift cylinder with 5P-0960 Molybdenum Grease .
Illustration 14 g00350673
Lift the lift arms. Remove Tooling (A) .End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".