SWITCH AS 8N2248 - Caterpillar

Illustration 1 g03094867
Left Side ViewShown with the standard sumpNote: Lubricate all bores and O-ring seals with lubricant before installing the O-rings seals. (1) Torque for O-ring plug ... 18 2 N m (13.3 1.5 lb ft)
Illustration 2 g03094937
Rear viewShown with the standard sumpNote: Lubricate all bores and O-ring seals with lubricant before installing the O-rings seals. (2) Apply 4C-4030 Thread Lock Compound to the threads of the bolt. Torque for bolt ... 28 7 N m (21 5 lb ft) (3) Torque for O-ring plug ... 18 2 N m (13.3 1.5 lb ft) (4) Torque for O-ring plug ... 12 3 N m (8.9 2.2 lb ft)
Illustration 3 g01523810
Bottom viewNote: Lubricate all bores and O-ring seals with lubricant before installing the O-rings seals. (5) Torque for 11 O-ring plugs ... 18 2 N m (13.3 1.5 lb ft)Control Manifold
Illustration 4 g01523813
Note: Lubricate all bores and O-ring seals with lubricant before installing the O-rings seals. (6) Torque for 15 bolts ... 10 1 N m (89 9 lb in) (6) (7) Torque for two shoulder screws ... 14 3 N m (124 27 lb in) (8) Liquid level sensor Input voltage ... 5 0.1 VDC Operating temperature ... −40 to +121 °C (−40 to +250 °F) Low output signal ... 0.9 V High output signal ... 4.5 V (9) Torque for O-ring plug ... 74 4 N m (55 3 lb ft) (10) Temperature sensor Tighten the two sensors to the following torque. ... 20 3 N m (15 2 lb ft) Operating temperature ... −40 to +150 °C (−40 to +302 °F) (11) Torque for O-ring plug ... 74 4 N m (55 3 lb ft) (12) Torque for O-ring plug ... 110 5 N m (81 4 lb ft)Transmission Hydraulic Control Valve