SWITCH AS 9G7204 - Caterpillar

Table 1
Required Tools
Tool Item Qty Part No Description
A 1 Laptop Computer with Plus+1TM Software
B 466-6258 Communication Adapter Gp
B1 1 317-7485 Communication Adapter
B2 1 370-4617 Cable As
B3 1 457-6114 Cable As
Drive the machine to a smooth, horizontal surface. Make sure that the machine is not articulated.
Illustration 2 g03356810
Move propel lever (1) to the NEUTRAL position.
Move parking brake switch (2) to the ON position.
Illustration 3 g03356814
Use throttle control switch (3) to operate the engine in ECO mode or in low idle.Note: Two things indicate when the engine is in ECO mode. First, "ECO" will appear on the display. Second, the second LED next to throttle control switch (3) will be illuminated. Two things indicate when the engine is at low idle. First"",Low Idle" will appear on the display. Second, the first LED next to the throttle control switch will be illuminated.
Move engine start switch (4) to the OFF position.
Illustration 4 g03883810
Connect Tool (B3) to diagnostic connector (5). Connect Tool (B2) to USB port on Tool (A).
Move engine start switch (4) to the ON position.
Illustration 5 g03883819
Click Plus+1TM icon (6) to launch the Plus+1TM program on Tool (E).Note: The connection instruction for the Plus+1TM service tool for Caterpillar® is published in Special Instruction, REHS7696. , "Software Installation Instructions of the Plus+1TM Service Tool for Caterpillar® (P1STC) Is available for Caterpillar Paving Products".
Illustration 6 g03888538
Click "Open Folder" icon (7) or "Open Folder" icon (8) to access the diagnostic files.
Illustration 7 g03888540
Select "CAT Diagnostic Files" folder (9). Click "Open" button (10).
Illustration 8 g03888542
Select "SCOM T4fWB.P1D" file (11) then click "Open" button (12).Note: The machine-specific diagnostic P1D file must be used with the P1STC program to communicate with the machine ECM.
Illustration 9 g03888793
Select the "Configuration" icon (13).
Illustration 10 g03888514
Select the "Vibratory System" (14).
Illustration 11 g03888524
The default setting is 35 percent.
Select the increase or decrease arrows (15) to select your value of engagement.
Illustration 12 g03888529
Select "Save" (16).
Close Plus+1TM.
Disconnect Tool (B) from diagnostic connector (5). Disconnect Tool (B) from USB port on Tool (A).
Move engine start switch (4) to the OFF position.