SWITCH AS-PRESSURE 9G8010 - Caterpillar

Illustration 1 g02009714
View of the right side of a GS388 Marine Genset
Illustration 2 g02009494
View of the left side of a GS388 Marine Genset
Universal Warning (1)These safety messages are located on each side of the terminal box.
Illustration 3 g01370904
Do not operate or work on this product unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Hot Surface (2)These messages are located on each side of the barrel of the generator.
Illustration 4 g01384734
Hot parts or hot components can cause burns or personal injury. Do not allow hot parts or components to contact your skin. Use protective clothing or protective equipment to protect your skin.
Hot Surface (3)These safety messages are located on each side of the engine.
Illustration 5 g01372256
Hot parts or hot components can cause burns or personal injury. Do not allow hot parts or components to contact your skin. Use protective clothing or protective equipment to protect your skin.
Explosion Hazard (4)This safety message is located on the air cleaner element.
Illustration 6 g02010075
Explosion Hazard! Spraying uncontrolled ether into the air inlet system can cause explosions or fire that may result in personal injury or death. Read and follow the starting procedures in the Operation and Maintenance Manual.
Hot Fluid Under Pressure (5)This safety message is located next to the cap on the heat exchanger.
Illustration 7 g01378799
Pressurized system! Hot coolant can cause serious burns, injury or death. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Read and understand the Operation and Maintenance Manual before performing any cooling system maintenance.
Lifting the Genset (6)This safety message for lifting the genset is located on the side panels of the terminal box.
Illustration 8 g01433231
Crushing Hazard! Improper lifting could cause serious injury or death. Follow the lifting instructions in the Operation and Maintenance Manual for safe lifting procedures.
Automatic Starting (7)The safety message for automatic starting is located on the sides of the terminal box.
Illustration 9 g01392484
When the engine is in the AUTOMATIC mode, the engine can start at any moment. To avoid personal injury, always remain clear of the the engine when the engine is in the AUTOMATIC mode.
Shock/Electrocution (8)
The safety message for electrical shock is located on the sides of the terminal box and the rear of the terminal box.
Illustration 10 g01392482
Do not connect the generator to a utility electrical distribution system unless it is isolated from the system. Electrical feedback into the distribution system can occur and could cause personal injury or death.Open and secure the main distribution switch, or if the connection is permanent, install a double throw switch to prevent electrical feedback. Some generators are specifically approved by a utility to run in parallel with the distribution system and isolation may not be required. Always check with your utility for the applicable circumstances.