SWITCH AS-PUSH BUTTON 9W0073 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tooling     Part Number     Description     Qty    
A     5P-7299 (1)     Installer     1    
438-9547 (2) Installer     1    
7F-8022 Bolt     1    
4B-4283 Washer     1    
B     4C-9500     Quick Cure Primer     1    
C     9S-3265     Compound     1    
( 1 ) Use to install 9Y-9895 seal
( 2 ) Use to install 362-8853 sealNote: The wear sleeve and the seal must be installed together.
Illustration 1 g00988346
Apply clean engine oil on the seal lip and on the outside diameter of wear sleeve (1) . Install the seal on the wear sleeve with the lip of the seal toward the side of the wear sleeve that has the chamfer on the inside diameter, as shown.
Illustration 2 g00988347
Use Tooling (B) in order to remove any oil from inside Diameter (X) of the wear sleeve and surface (Y) of the crankshaft.
Apply Tooling (C) to Surfaces (X) and (Y) .
Install the seal and wear sleeve (1) on the crankshaft with the lip of the seal toward the engine, as shown.
Install Tooling (A) , as shown. Place lubricant between the bolt head and the installer.
Use Tooling (A) in order to push the seal and wear sleeve (1) on the crankshaft. Push the installer until the installer is against the end of the crankshaft. The wear sleeve and the seal are now in the correct location.
Remove Tooling (A) .End By: Install the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Install" for the engine that is being serviced.