SWITCH AS-PRESSURE 9X6855 - Caterpillar

Illustration 1 g00984526
(A) Bucket cylinder (B) Bucket control linkage (C) Bucket (D) Stick cylinder (E) BoomNote: All bores must be free of paint. Coat all bores for pins with lubricant. (1) Lubricate the sealing lip slightly with the lubricant that is being sealed.Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward. (2) Two 163-3744 Sleeve Bearings Outside diameter ... 106.142 0.008 mm (4.1788 0.0003 inch) Inside diameter ... 90.27 0.02 mm (3.554 0.001 inch) Install the bearing in the bearing bore. ... 9.5 0.8 mm (0.37 0.03 inch) (3) 4I-4811 Pin Assembly Diameter after plating ... 69.850 0.025 mm (2.7500 0.0010 inch) Minimum thickness for plating ... 0.005 mm (0.0002 inch) Bore diameter for the pin ... 70.0 mm (2.76 inch) (4) Use the necessary shims to adjust the lateral clearance. 166-1486 Shim ... 2.0 mm (0.08 inch) (5) Two 163-3749 Sleeve Bearings Outside diameter ... 85.160 0.013 mm (3.3527 0.0005 inch) Inside diameter ... 70.267 0.037 mm (2.7664 0.0015 inch) Install the bearing in the bearing bore. ... 7.5 0.8 mm (0.30 0.03 inch) (6) 4I-4809 Pin Assembly Diameter after plating ... 79.850 0.025 mm (3.1437 0.0010 inch) Minimum thickness for plating ... 0.005 mm (0.0002 inch) Bore diameter for the pin ... 80.0 mm (3.15 inch) (7) Two 137-2919 Sleeve Bearings Outside diameter ... 95.180 0.013 mm (3.7472 0.0005 inch) Inside diameter ... 80.2925 0.0425 mm (3.1611 0.0017 inch) Install the bearing in the bearing bore. ... 7.5 0.8 mm (0.30 0.03 inch)