SWIVEL GP 3718588 - Caterpillar

Graphical Display
The following is a list of Diagnostic Trouble Codes (DTCs) that are associated with the Graphical Display.
Table 1
Graphical Display (MID 53)
DTC Description System Response
268-02 Programmed Parameter Fault: Data erratic, intermittent, or incorrect The Graphical Display has determined that a configuration parameter is not programmed. The Graphical Display will display the parameter causing the problem on the Cat® Electronic Technician (Cat ET) Service Tool. The programming parameters identify conditions related to the programming of the Graphical Display or a signal failure. A failure of the internal program of the Display is associated with this diagnostic code as well. The fault messages displayed in Cat® Electronic Technician (Cat ET) Service Tool or via the operator monitor include "programmed parameter fault" or other machine monitoring failures.Possible causes for an FMI 02 diagnostic code are:
The sales model and product identification are not programmed into the Display.
The Graphical Display is incorrect.Note: The correct sales model and product identification must be programmed when new software is flashed to the Display.Diagnostic Trouble Code Procedure
Identify the active FMI code associated with the components.
Determine which code is present and use the list below to determine which procedure to follow.
FMI 02 diagnostic code, proceed to Table 2.
Table 2
FMI 02 Troubleshooting
Troubleshooting Test Steps Values Results
1. Verify The Configuration Of The Sales Model.
A. Use the Cat® Electronic Technician (Cat ET) Service Tool to verify that the Display is configured to the default setting configuration.
The Display has been configured correctly to the default setting configuration. OK - The Display has been configured correctly to the default setting configuration.
Verify that the new configuration has corrected the problem before attempting to operate the machine.
Proceed to Test Step 3.
NOT OK - The Display does not have the appropriate sales model and product identification.
Proceed to Test Step 2.
2. Configure The ECM.
A. Use Cat ET to reset the configuration to the default setting configuration. Enter the correct information for sales model and product identification.
B. Reset the installation status to the correct type for the attachments that are installed on the machine.
The Display is configured to the default setting configuration. OK - The Display is configured to the default setting configuration.
Verify that the new configuration has corrected the problem before attempting to operate the machine.
Proceed to Test Step 3.
NOT OK - The Display is not configured to the default setting configuration.
Repair: Repeat this procedure.
If the diagnostic code remains active or repeatedly activated and no cause can be found, flash the Display with the latest software version. Ensure that you have the latest software version for your specific machine and Display. Refer to the Testing and Adjusting, "Module - Flash Program" section of this manual for the correct procedure.
If the problem is still present after flashing the latest software to the Display, contact the Technical Communicator at your dealership for a possible consultation with Caterpillar.
Proceed to Test Step 3.
3. Check If The Diagnostic Code Remains
A. Turn the key start switch and the disconnect switch ON.
B. Clear all diagnostic codes.
C. Operate the machine.
D. Stop the machine and engage