TACHOMETER GP-ELECTRIC 2752103 - Caterpillar

3400 Family Of Commercial EnginesNew, stronger, perforated steel core gaskets are available for use between the cylinder block and the front housing and the flywheel housing. These steel core gaskets can not be trimmed. The gaskets are sized so that when installed, the gaskets are recessed slightly from the bottom of the cylinder block. Therefore, the following procedure is REQUIRED for installing the new steel core gaskets.
Steel Core Gasket Installation Procedure
1. Clean the gasket faces of the cylinder block, both sides of the front plate, and gasket faces of the housings of all oil, fuel, water, dirt, assembly compounds, and any other foreign material.2. Apply a bead of 8T-9022 RTV Blue Silicone Sealant to both the right and left edges of the cylinder block [marked(X)] prior to installing the gasket. See Illustration 1.
Illustration 1. Lower edges (X) of the cylinder block prior to installing gasket.3. Install the gasket on the cylinder block and apply a bead of 8T-9022 RTV Blue Silicone Sealant to the bottom edge of both the right and left sides of the new gasket [marked(Y)] prior to installing the housing. See Illustration 2. Repeat Step 3 after installing the front plate.
Illustration 2. Lower edges (Y) of the new steel core gasket prior to installing the housing.4. Install the housings and tighten the bolts as per instructions in the appropriate Disassembly And Assembly Manual.5. Remove the excess 8T-9022 RTV Blue Silicone Sealant from the "T-joints" at the cylinder block (plate), housing, and oil pan joint. Use a suitably sized, flat, straight edged tool (free of oil, fuel, water, dirt, and any other foreign material), such as a putty knife to remove the excess sealant. DO NOT use fingers or towels to remove the excess 8T-9022 RTV Blue Silicone Sealant. The use of fingers or towels will not leave a flat sealing surface which could result in a leak.
Illustration 3. Using a straight edged tool (Z) to remove excess 8T-9022 RTV Blue Silicone Sealant from a "T-joints".