TACHOMETER 4616518 - Caterpillar

Do Not Weld on FOPS (6)
Illustration 12 g01211448Safety Message (6) is located on the right rear post of the FOPS cab.
Illustration 13 g01211451
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
Do Not Weld On ROPS (7)
Illustration 14 g01211452Safety Message (7) is positioned on the vertical support of the outside right ROPS post.
Illustration 15 g01211454
Structural damage, an overturn, modification, alteration, or improper repair, can impair this structure's protective capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
Hot Coolant Under Pressure (11)
Illustration 16 g01211456Safety Message (2) is located under the access door to the radiator cap.
Illustration 17 g00782457
Pressurized system: Hot coolant can cause serious burn. To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure.
Seat belt (12)Safety Message (10) is located on the left side of dash panel.
Illustration 18 g01211636
A seat belt should be worn at all times during machine operation to prevent serious injury or death in the event of an accident or machine overturn. Failure to wear a seat belt during machine operation may result in serious injury or death.
LaserIf your machine is equipped with the AccuGrade - Laser System, this safety message is located on each leg of the tripod for the laser.
Illustration 19 g01211459
Movement of the transmitter could cause unexpected blade movement. Death or serious injury could occur. Turn off the transmitter before you move the transmitter or before you adjust the transmitter.