TACK-FASTENER 9X6562 - Caterpillar

Function Keys and Navigation Keys
Illustration 1 g01211086
(1) Display screen (2) Yellow warning lamp (3) Red shutdown lamp (4) Alarm acknowledge/silence key (5) Lamp test key (6) Stop key (7) Auto key (8) Run key (9) Escape key (10) Enter key (11) Scroll right key (12) Scroll down key (13) Scroll up key (14) Scroll left key (15) Engine overview key (16) AC overview keyEscape (9) - Used to navigate up (backward) through the menu structure and to back out of data entry screens during set point programming.Enter key (10) - Select a highlighted menu item or save a programmed value.Scroll Right key (11) - During numeric data entry, choose the digit to edit. During certain set point adjustments, select or deselect a check box.Scroll Down key (12) - Move down through the main menu or navigate within a list in order to highlight one of the items. Also used to decrement digits (0-9).Scroll Up key (13) - Move up through the main menu or navigate within a list in order to highlight one of the items. Also used to increment digits (0-9).Scroll Left key (14) - During numeric data entry, choose the digit to edit. During certain set point adjustments, select or deselect a check box.Initial Setup
Information from the EMCP 3 is displayed on the display screen (1) . Press the scroll up key or the scroll down key in order to highlight the main menu options.Press the enter key in order to select one of the main menu options. The keypad is also used in order to change the set points. Press the enter key in order to change a set point. Press the scroll up key or the scroll down key in order to increase or decrease the value. Press the scroll left key or the scroll right key in order to change the digit that is to be adjusted.Note: The EMCP 3 panel will power up to the main menu screen. If the EMCP 3 panel is already powered up, press the escape key in order to return to the main menu. Each press of the escape key moves you back one level in the menu structure.Set Points
Within each set point category there are one or more function blocks. Each of those function blocks may contain one or more set points. Each of the set point categories and corresponding function blocks are shown below.Control
Automatic start/stop
Automatic voltage regulator (AVR) desired voltage request
Generator desired engine speed requestEngine Monitor/Protect
Battery voltage monitor
Crank attempt/successful start counter
Engine coolant temperature monitor
Engine oil pressure monitor
Engine speed monitor
Enhanced engine monitor
Service maintenance intervalEvents
Diagnostics configuration
Engine protection events configuration
Generator protection events configuration
Other system events configuration
Custom events
Event output function
Event systemGenerator Monitor/Protect
Enhanced generator monitor
Generator AC monitor
Generator AC power monitor
Generator over current
Generator over/under frequency
Generator over/under voltage
Generator reverse powerInput/Output (I/O)
Digital inputs
Digital outputs
Relay outputs
Spare analog inputNetwork
Data Link - SCADAOther
Digital selectors
Reduced power modeMenu Maps
The maps in this section are to be used as a guide when programming the EMCP 3. Maps are provided for all versions of the controller.
Illustration 2 g01231819
Illustration 3 g01233949
Illustration 4 g02992757
Programming the Display