TANK AS-COOLANT 0965819 - Caterpillar

Using one strap (5), secure the harness to the hose. Refer to Illustration 10 for location.
Illustration 11 g03416566
(5) 178-3620 Strap
Using two straps (5), secure the harness to the hose at the pivot point.
Illustration 12 g03416568
(5) 178-3620 Strap
Using two straps (5), secure the harness inside the left rear tower.Note: Coil and secure any excess harness inside the left rear tower.Installing the Work Tool Rocker Switch
Illustration 13 g03416620
(6) 263-5418 Rocker Switch
Release the tabs on the switch cover on the left-hand console. Remove the switch cover.
Remove the plug from the switch cover from the position shown in Illustration 13.
Install switch (6) into the opening in the switch cover. Press switch in until all tabs are fully engaged.
Inside the console, locate the LC-8 connector on the 378-1026 Panel Harness As and connect the connector to the switch installed in Step 3. Refer to Table 3 to confirm the correct connector configuration.
Reinstall the switch cover onto the left-hand console.Installing the Relays
Locate the fuse panel in the rear of the cab at the right-hand side.
Illustration 14 g03416627
(3) 146-9439 Relay As
Install the five relays (3) into positions "R1" through "R5" on the upper fuse block.Removing the Current Left Hand Joystick
Note: Retain hardware for reuse in the installation of the new joystick controller.
Illustration 15 g03416625
Console Cover on mechanical seat.
Illustration 16 g03416633
Console Cover on air ride seat.
Remove the two screws from the outside Console Cover.
Illustration 17 g03416634
Console Cover on mechanical seat.
Illustration 18 g03417169
Console Cover on air ride seat.
Remove the four screws from the inside Console Cover.
Illustration 19 g03417297
Remove the console covers from the seat.Note: Do Not use any type of prying tools to remove the covers as tools may damage the covers.
Illustration 20 g03417298
Raise the 217-9053 Boot from the current joystick.
Illustration 21 g03417300
Remove the four bolts securing the joystick to the armrest. Remove straps retaining the connector to the joystick harness, if necessary. Disconnect the harness.Installing the New 379-1615 Joystick Control Gp
Connect the joystick 12-pin connector to the CH-C4 connector on the seat desk harness. Connect the joystick 6-pin connector to the CH-C5 connector of the seat deck harness. Refer to Table 4 and 5 to confirm the correct connector configuration.
Secure the connectors by using two straps (12).
Secure joystick (8) to the armrest using four bolts (2). Tighten the bolts to a torque of 6 1 N m (53 9 lb in)
Return boot to original position.
Reinstall covers onto the left armrest.