TANK AS-FUEL 1G6212 - Caterpillar

Table 1
Required Tools    
Part Number    Part Description    Qty    
9U-7400     Multitach     1    
    Stopwatch     1    
Position the machine on level ground and stop the engine.
Install 9U-7400 Multitach on the lower carriage in order to check the drive shaft speed.
Attach a reflective tape to the drive shaft.
Start the engine.
Lower the left console.
Place the engine speed dial at the HIGH IDLE position.
Fully move the stick several times until the normal hydraulic oil temperature of 55° 5°C (131° 9°F) is reached.
Illustration 1 g00294504
Lower the stabilizer, the blade tip, and/or the implement in order to raise the front axle and the rear axle. This will allow the wheels to turn freely. All tires must be off the ground.
Place the machine in second gear. Place the engine speed dial at the HIGH IDLE position.
Depress the travel pedal for FORWARD travel. Allow the machine to operate in forward travel for one minute in order to stabilize the drive shaft speed.
Measure drive shaft speed.
Depress the travel pedal for REVERSE travel. Allow the machine to operate in reverse travel for one minute in order to stabilize the drive shaft speed.
Measure drive shaft speed.
If the drive