TANK GP-HYDRAULIC 2447440 - Caterpillar

Disable Regeneration - Push in the bottom of the switch for 2 seconds to deactivate automatic regeneration and/or stop an active DPF regeneration cycle. A "Regen Disabled" message will be displayed on the monitor.Note: To re-enable auto regeneration, cycle the engine start switch to OFF and back to ON.For more information, refer to Operation and Maintenance Manual, "Diesel Particulate Filter Regeneration".Cab Tilt (24)
Cab Tilt - Press the switch to tilt cab. The indicator lamp will turn on.Note: Remove Rock Pin for Tilt Cab before tilting Cab. For more information refer to Operation and Maintenance Manual, Cab Tilt Control.Sky Window Wiper and Window Washer (25-26) (If Equipped)
Sky Window Wiper (25) - Push down on the top of the switch to turn on the lower window wiper. Push down the bottom portion of the switch to turn off the sky window wiper.
Sky Window Washer (26) - Push down on the top of the switch and keep the switch depressed to activate the lower window washer. While the switch is depressed, the washer fluid will spray from the nozzle.
If the wiper does not operate with the switch in the ON position, turn the switch off immediately. Check the cause. If the switch remains on, motor failure can result.
If the washer is used continuously for more than 20 seconds or used when no washer solution comes out, motor failure can result.
Boom Float Control (27)
Boom Float Control - If equipped, press the switch to turn on the boom control pressure function. The boom pressure control function improves controllability for low load operation such as raking up rocks by reducing vibration and shock.Overload Warning Device (28)
If equipped, the switch for the overload warning device is on the right console.
Overload Warning Device - In lifting applications, the overload warning device activates a buzzer when there is an unstable load condition. When the buzzer sounds, the bucket load should be reduced or the stick should be moved inward.
ON - Push the right side of the switch to activate the overload warning device.
OFF - Push the left side of the switch to deactivate the overload warning device.Boom Coupler switch (29)
Illustration 16 g06053246Move the boom coupler switch to lock and unlock position. "Boom Coupler Unlock" will appear on the monitor.Radio Mute Switch (30)
Radio Mute Switch - Press the switch to mute the radio. The indicator lamp will turn on.Beacon Lamp Switch (31)
Beacon Lamp Switch - If equipped, push in the top of switch to turn on the warning beacon lamp. Push in the bottom of switch to turn off the warning beacon lamp.Service Port
Illustration 17 g03320855
Electronic Technician service port
An Electronic Technician (ET) service port is located inside the cab behind the seat. This service port allows service personnel to connect a laptop computer that is equipped with Electronic Technician. Service personnel can use electronic technician to diagnose machine and engine systems.Contact your Cat dealer for additional information.