TANK GP-EXPANSION 2500838 - Caterpillar

Click "Program"27. The message "Programming the Flash" willappear on the left of the progress bar. The bar will move from left toright and display a number in % that will increase form 0% to 100% as thebar moves right. Simultaneously the message "Code update: receiving data"will appear in UPS View. After the progress bar reaches 100% the next messagein UPS View will be "Code update: updating flash." When the progress barhas reset to 0% it will begin again with the message "Read Back Flash Program"to the left of it. When the progress bar has reached 100% then read backchecking has finished. The progress bar will reset to 0 and display themessage "completed with no errors" on the left of it. UPS View will displaythe message "Code update: successful." If an error has occurred then pressProgram to retry the process.28. Next, proceed by selecting "Byte- wideFlash PowerPC" as the target.29. Click Browse, find and select/ click thefile APSBoot3_ 12. mot. This file is either on a floppy disk or on yourhard drive where it was saved.30. Click "Open"31. Click "Program"32. The message "Programming the Flash" willappear on the left of the progress bar. The bar will move from left toright and display a number in % that will increase form 0% to 100% as thebar moves right. Simultaneously the message "Code update: receiving data"will appear in UPS View. After the progress bar reaches 100% the next messagein UPS View will be "Code update: updating flash." When the progress barhas reset to 0% it will begin again with the message "Read Back Flash Program"to the left of it. When the progress bar has reached 100% then read backchecking has finished. The progress bar will reset to 0 and display themessage "completed with no errors" on the left of it. UPS View will displaythe message "Code update: successful." If an error has occurred then pressProgram to retry the process.33. Reset the processor. Press Ctrl< R>and "Y" to confirm.34. There will only be a few seconds to performthis step. During the boot process wait for the message "Pausing for operatorinput" to appear then, perform a Ctrl< I>.35. This will stop the booting process. Ifthe processor continues to boot then wait until it finishes and rebootthe processor again. Then pause the process by performing a (Ctrl< I>).36. Next, proceed by selecting "Serial FPGA20k" for the target.37. Click Browse, find and select/ click thefile apc_ 110. ttf. This file is either on a floppy disk or on your harddrive where it was saved.38. Click "Open"39. Click "Program"40. The message "Programming the Flash" willappear on the left of the progress bar. The bar will move from left toright and display a number in % that will increase form 0% to 100% as thebar moves right. Simultaneously the message "Firmware update: receivingdata" will appear in UPS View. After the progress bar reaches 100% thenext message in UPS View will be "Firmware update: updating flash." Whenthe progress bar has reset to 0% it will begin again with