TANK GP-MTG& 3157088 - Caterpillar

Turn heater hose valves (1) to the OFF position.
Illustration 2 g02469116
Remove covers (2).
Illustration 3 g02469196
Disconnect harness assemblies (3). Disconnect hoses (4). Cut cable straps (5).
Illustration 4 g02469277
Disconnect harness assembly (6) and cut cable straps (7).
Illustration 5 g02469336
Attach Tooling (A) and a suitable lifting device to bracket and tank assembly (8). The weight of bracket and tank assembly (8) is approximately 68 kg (150 lb). Remove the bolts and bracket and tank assembly (8).
Remove panel assembly (9).
Illustration 6 g02470140
Remove bolts (10). Remove duct assembly (11) and the gaskets.
Illustration 7 g02470256
Disconnect hose assemblies (12) and (13).
Disconnect tube assembly (14).
Cut cable strap (15) and disconnect harness assemblies (16).
Remove hose clips (17). Disconnect bracket assembly (18) and set aside.
Illustration 8 g02470500
Remove bracket assembly (19) and dryer assembly (20) as one unit.
Illustration 9 g02470837
Disconnect hoses (21) and harness assembly (22).
Illustration 10 g02471996
Disconnect harness assembly (23).
Remove bracket assembly (25), accumulator (24), and the hose assemblies as one unit.
Illustration 11 g02472036
Illustration 12 g02472096
Remove the bolts and slide conditioner assembly (26) outward approximately 203 mm (8.0 inch).
Attach one half of Tooling (B) and a suitable lifting device to conditioner assembly (26). The weight of conditioner assembly (26) is approximately 68 kg (150 lb).
Illustration 13 g02472236
Slide conditioner assembly (26) outward far enough to attach the remaining Tooling (B) and an additional suitable lifting device. Use Tooling (B) and the suitable lifting device in order to remove conditioner assembly (26) from the machine.
Illustration 14 g02475392
Disconnect harness assembly (27). Remove fir tree mount (28). Separate case (29) from case (30).
Illustration 15 g02476788
Disconnect harness assemblies (33). Cut cable strap (32). Remove the bolts and remove blower motor (31). Installation Procedure
Install blower motor (31) in the reverse order of removal.
Tighten bolts (10) to a torque of 6 1 N m (53 9 lb in).