TANK GP-TRANSMISSION 3236799 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0820 Hydraulic Puller 1
4C-9633 Puller Stud 1
8B-7548 Push-Puller Tool Gp 2
3H-0465 Push-Puller Plate 8
8T-1757 Nut 8
9X-8268 Hard Washer 8
169-6969 Threaded Rod 4
9U-6600 Hand Hydraulic Pump 1 Start By:
Remove the track roller frame (front).
Remove the track adjuster.
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Illustration 1 g00976493
Illustration 2 g00976494
Position Tooling (A) 280 mm (11.0 inch) away from the roller frame.
Adjust the puller stud so that 25.4 mm (1.00 inch) of travel is allowed. Center the lead bolt onto tube assembly (2).
Apply enough pressure to tube assembly (2) so that tube assembly (2) is off nut (1). Back off nut (1) by a distance of 12.7 mm (0.50 inch). Slowly release the pressure. Note: Do not adjust nut (1) more than 13 mm (0.5 inch) at a time.
Repeat Step 1 through Step 3 until nut (1) is removed.
Remove tube assembly (2).
Illustration 3 g00976495
Attach a suitable lifting device to spring (3). Remove spring (3). The weight of spring (3) is approximately 32 kg (70 lb). Installation Procedure
Install spring (3) in the reverse order of removal. Note: The face of nut (1) should be 7 2 mm (0.276 0.079 inch) from the face of the front track roller frame.End By:
Install the front track roller frame. Refer to Disassembly and Assembly, "Front Track Roller Frame - Install".
Install the track adjuster. Refer to Disassembly and Assembly, "Track Adjuster - Remove and Install".