TANK GP-FUEL 3946523 - Caterpillar

Table 1
D250D PIN: (6NG1-Up)
and D250E PIN: (5TN1-256)
   
Item     Quantity     Part Number     Description    
A     3     6B-5310     Bolt    
Table 2
D250E PIN: (5TN257-Up)
and D300E PIN: (7FN1-Up)
   
Item     Quantity     Part Number     Description    
A     3     0S-1575     Bolt    
Table 3
D250E Series II and D300E Series II    
Item     Quantity     Part Number     Description    
A     3     8T-4187     Bolt    
Illustration 1 g00695782
Remove the equalizing arm for the rear suspension from the machine.
Remove the two 7U-7292 Bushings from the equalizing arm.
Install the inner 175-3587 Bushing to the pivot for the equalizing arm. Lubricate the bushing with 5P-3931 Anti-Seize Compound .
Install the equalizing arm onto the machine.
Install the outer 175-3587 Bushing to the equalizing arm. Lubricate the bushing with 5P-3931 Anti-Seize Compound .
Install the end cap. Use three longer bolts (A) in order to seat the bushings and provide some initial compression. Refer to tables 1, 2 and 3 in order to determine the correct bolt to use. Tighten the bolts in order to provide an equal compression of the bushings. Apply 5P-3931 Anti-Seize Compound to all internal threads.
When sufficient compression has been provided to allow the original bolts and washers to be installed, remove one bolt (A). Install one of the original bolts and one washer. Tighten the bolt to the required torque. Refer to Service Manual, SENR3130, "Torque Specifications".
Repeat step 7 on the remaining bolts (A) .
Complete the installation of the equalizing arm.