TANK AND VALVE GROUP 4D1755 - Caterpillar

Illustration 1 g01458541
Select "Wireless Communication Support".
Illustration 2 g01319860
Select "Yes" in order to enable the wireless communication.When "Yes" is selected, the radio will need to be configured for "EZ IP" or "IP". Use MCG Flash in order to configure the radio.The IP address must match the radio for the office. The radio network will be disabled.Wireless Communication
Note: The wireless communication option is only supported by 900Mhz radios.AccuGrade Wireless Communication is an available option for the AccuGrade CD700 display. This option can be purchased and installed on each CD700 display. The wireless communication option allows the supervisor to perform the following:
Transmit updated design information to the machines on the site.
Perform basic remote diagnostics.
Send simple text messages to the machines.Procedure to Purchase the Option Key
Refer to the appropriate AccuGrade price list in order to purchase the option key.
Order the key per the instructions on the price list.
Record the following information:
Reference number for the wireless key
Dealer code of the dealer that orders the key
Reference number of the order
Obtain the serial number from the identification plate on the display. Record the number. The number is required in order to activate the wireless communication option.
Proceed to the web site: "www.techproductregistration.com".Refer to Special Instruction, REHS3666, "Software Activation for the AccuGrade® Display" for additional information.After the order is completed an e-mail message will be sent to the e-mail address that was entered into the form. This message will arrive within thirty minutes. This e-mail message will contain the option key number that is used in order to activate the option key on the requested display. A phone call will be made to the phone number that was submitted on the form in order to confirm that the e-mail message with the option key was received. Provide the key to the appropriate person so that the key can be installed on the display. Save the information that pertains to the option key for future reference. An invoice will be sent from Antares for the purchase of the option key.Enter the Option Key into the Display
Turn the key start switch for the machine to the ON position.
Start the display in service mode. In order to enter service mode, hold down the "OK" key while the display powers up.
Press the "Setup Menu" key.
Illustration 3 g01458541
Press the "Installation" soft key.
Use the arrow keys (14) in order to select "Software Support Option".
Press the "OK" key (16) .
Perform one of the two options below:
Copy the file for the wireless option key to the root directory of a data card. Insert the data card. The display will read the key.
Enter the 24 character option key that was obtained above. Use the arrow keys on the display in order to enter the key. Press the "OK" key.If the procedure is successful, the "Option Keys File Loaded" dialog appears. The dialog will indicate that a option key has been loaded successfully.
Press the "OK" Key.The plan view appears.Note: If the key does not activate check the following:
Verify that the key was entered correctly.
Verify that the serial number that is