TANK AS 5362023 - Caterpillar

Illustration 9 g00628722
Install six dowels (24) in the housing.
Start with a disc and install two discs (20) and plate (19). Alternate the discs and the plates.
Put the twelve springs in position in the housing.
Put seals (22) and (23) in position in the grooves in piston (17), as shown.
Put piston (17) in position in housing (18).
Install Tooling (F) in order to hold the piston in housing (18).
Fasten a suitable lifting device and Tooling (K) to housing (18). Put the housing in position on the planetary group. Install the two bolts that hold the housing in place.
Use Tooling (J) to install bearing (11) in manifold (16). Install the bearing in the manifold. Install the notch in the inner race of the bearing toward the inside of the manifold.
Use Tooling (E). Install snap ring (15) in order to hold the bearing in place.
Fasten a suitable lifting device and Tooling (C) to manifold (16). Put manifold (16) in position on the planetary group. Install bolts (21) that hold the manifold in place. Tighten the bolts to a torque of 115 7 N m (85 5 lb ft).
Fasten a suitable lifting device and Tooling (G) to the housing. Lift the planetary carrier. Expose the groove in the output shaft.
Use Tooling (D) to install snap ring (14) in the groove in the output shaft.
Put clean SAE 30 oil on the lip of seal (13). Put seal (13) in position on the manifold. Install bolts (12).
Illustration 10 g00628734
Use the following procedure to make sure that the pistons are free in the clutch housings:
Use Tooling (L) to put air that is free of water under a pressure of 690 to 1030 kPa (100 to 149 psi) into each of the five oil passages.
If the pistons do not move, put a small amount of clean SAE 30 oil in each passage. Check for movement again. If the pistons do not move, the transmission must be disassembled. Check the seals.
Illustration 11 g00628740
Put screen (10) in position in