TANK AS 5506373 - Caterpillar

Light Switches
1. Headlights - Push the top of the switch in to turn the headlights off.Push the bottom of the switch in to turn the headlights on. 2. Hazard Flashers - Push the top of the switch in to turn the hazard flashers off.Push the bottom of the switch in to turn the hazard flashers on.When the switch is in the on position, the switch light, the outside lights and the signal light indicator will flash. An audible horn will also sound. 3. Front Working Lights - Push the top of the switch in to turn the front working lights off.Push the bottom of the switch in to turn the front working lights on. 4. Rear Working Lights - Push the top of the switch in to turn the rear working lights off.Push the bottom of the switch in to turn the rear working lights on.Directional Turn Switches
Left Turn Signal - Pull lever back to position (1) to turn the left signal lights on. Right Turn Signal - Push lever forward to position (3) to turn the right signal lights on.Position (2) is the off position.Low - High Beam Light Switch
Low Beam Lights - Push down on the lever to turn on the low beam headlights. High Beam Lights - Lift up on the lever to turn on the high beam headlights.Dome Light
Dome Light - Turn the light clockwise to activate the dome light.Turn the light counterclockwise to turn it off.Lighter
Lighter - Push the lighter knob in to activate. The lighter will move out when it is ready to use.Windshield Wiper/Washer (If Equipped)
1. Windshield Wiper/Washer - Upper - Push the switch down to the first position to activate the upper window wiper. Push all the way down to activate the washer fluid. 2. Windshield Wiper - Lower - Push down to operate lower front window wiper.Horns
Horn - Push the signal lever (1) in to activate the horn. Push the floor switch (2) down to activate the auxiliary horn, if equipped.Travel Alarm (If Equipped)
Travel Alarm - The travel alarm sounds anytime either the forward or reverse travel pedal is depressed. It is used to alert people near the machine that it is moving. A three position adjustable switch (high, medium and low) on the rear of the alarm regulates its volume.The alarm is set at the highest sound level when shipped from the factory. The setting should remain on high, unless the job-site requires a lower level. Push the switch down to stop the alarm from sounding. If the switch is pushed after the machine is in motion, the alarm will continue to sound for six to ten seconds.Heating Controls (If Equipped)
1. Fan Switch - Controls the different speeds of the blower fan behind seat. Turn the knob to the desired speed or to OFF. 2. Recirculated Air - Raise the lever all the way for 100% recirculated air. Recirculated and Outside Air Mixture - Push the lever all the way down for 50% recirculated and 50%