TANK ASSEM. 6K6834 - Caterpillar

Full Torque Setting (FTS)
FTS is similar to FLS. Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter.Total Tattletale
The total tattletale counts the number of changes to system parameters.Engine Prelube
The "Engine Prelube" lubricates the internal engine components prior to starting the engine. This is a Software Enabled Attachment.Engine Fan Reversing Feature
The "Engine Fan Reversing Feature" aids in clearing debris from the radiator.Engine Fan Control
The "Engine Fan Control" allows the customer to control the operation of the engine cooling fan.Engine Fan Control Maximum (Clip) Pump Pressure
The "Engine Fan Control Maximum (Clip) Pump Pressure" is set at the factory in order to limit the pressure that is produced by the cooling fan's hydraulic pump.Security System Immobilizer Installation Status
This feature enables the ECM to provide the functionality for the installation of a Machine Security System (MSS). Parameter Table
Table 1
System Configuration Parameters
Parameter Available Range or Options Default Required Password
Configuration Group 1
Equipment ID 17 alphanumeric characters Blank None
ECM Identification Parameters
Engine Serial Number 0XX00000 or XXX00000 Blank Factory
ECM Serial Number Hardware Dependent Blank Read Only(1)
ECM Part Number Hardware Dependent Blank Read Only(1)
Software Group Part Number Software Dependent Read Only(1)
Software Group Release Date Software Dependent Read Only(1)
Software Group Description Software Dependent Read Only(1)
System Parameters
FLS Programmed at the Factory Factory
FTS Programmed at the Factory Factory
Total Tattletale 0 to 65535 0 Read Only(1)
Engine Configuration Parameters
Engine Prelube(2) On
Off On None
Engine Fan Reversing Feature Enabled
Disabled Disabled Customer
Engine Fan Control On
Off On Customer
Engine Fan Control Maximum (Clip) Pump Pressure 0 to 20000 kPa (0 to 2900 psi) 0 Customer
Security System Immobilizer Installation Status Installed
Not Installed Not Installed Factory
(1) This parameter can be viewed only. No changes are allowed.
(2) This is a Software Enabled Attachment.Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters
Equipment ID
Engine Serial Number
ECM Serial Number
ECM Part Number
Software Group Part Number
Software Group Release Date
Software Group Description
FLS
FTS
Total Tattletale
Engine Prelube
Engine Fan Reversing Feature
Engine Fan Reversing Feature
Engine Fan Control
Engine Fan Control Maximum (Clip) Pump Pressure
Security System Immobilizer Installation Status
Table 3
Information From Engine Information Plate
Engine Serial Number
FLS
FTS
Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Use of incorrect parameters could cause damage to the engine. Use of the incorrect parameters may also void the Caterpillar warranty or the emission certification for the engine.