TAP-HIGH SPEED 1P3039 - Caterpillar

"Customer Specified Parameters"
Customer specified parameters allow the engine to be configured to the exact needs of the application.Customer parameters may be changed repeatedly as a customer's operation changes."Low Idle Parameters"
"Low Idle Speed"
The "Low Idle Speed" is the minimum engine rpm.Low Battery Elevated Idle Parameter
"Low System Battery Voltage Elevated Idle"
The "Low System Battery Voltage Elevated Idle" will elevate the engine's low idle speed when the machine is not working and the battery voltage is low. "Fan Control Parameters"
"Hydraulic Cooling Fan Map"
The "Hydraulic Cooling Fan Map" provides a default value for fan speed if the correct fan speed is unavailable."Engine Fan Reversing Feature"
The "Engine Fan Reversing Feature" provides the option of reversing the direction of the fan in order to dislodge any obstructions."Engine Fan Reverse Operation Mode"
The "Engine Fan Reverse Operation Mode" permits the "Engine Fan Reversing Feature" to be automatic or manual."Security Access Parameter"
"Security System Immobilizer Installation Status"
The "Security System Immobilizer Installation Status" allows the "security system immobilizer" to be installed or not installed."ECM Identification Parameter"
"Equipment ID"
"Equipment ID" is the identification of the equipment that is assigned by the customer. The "Equipment ID" is only for reference by the customer. The "Equipment ID" is not required by the ECM."Customer Specified Parameters Table"
Table 2
Customer Specified Parameters    
ECM Parameter    Possible Values    Default Value    
Low Idle Parameters    
"Low Idle Speed"     700 to 1200 rpm     750 rpm    
Low Battery Elevated Idle Configuration Parameter    
"Low System Battery Voltage Elevated Idle "     Not Installed
Installed     Not Installed    
Fan Control Parameters    
"Hydraulic Cooling Fan Map"     Standard
High Ambient     Standard    
"Engine Fan Reversing Feature"     Disabled
Enabled     Disabled    
"Engine Fan Reverse Operation Mode"     Manual
Automatic     Automatic    
Security Access Parameter    
"Security System Immobolizer Installation Status"     Not Installed
Installed     Installed    
ECM Identification Parameter    
"Equipment ID"     17 Digits
Available characters are dependent on the service tool that is used     Not Programmed    "Customer Specified Parameters Worksheet"
Table 3
Customer Specified Parameters Worksheet    
Low Idle Parameters    
"Low Idle Speed"        
Low Battery Elevated Idle Configuration Parameter    
"Low System Battery Voltage Elevated Idle "        
Fan Control Parameters    
"Hydraulic Cooling Fan Map"        
"Engine Fan Reversing Feature"        
"Engine Fan Reverse Operation Mode"        
Security Access Parameter    
"Security System Immobolizer Installation Status"        
ECM Identifications Parameters    
"Equipment ID"        
J1939 Continuous Fault Handling    "System Configuration Parameters"
System configuration parameters affect the emissions of the engine or the power of the engine. System configuration parameters are programmed at the factory. Normally, system configuration parameters would never need to be changed through the life of the engine. System configuration parameters must be reprogrammed if an ECM is replaced. System configuration parameters do not need to be reprogrammed if the ECM software is changed. Factory passwords are required to change these parameters. The following information is a description of the system configuration parameters.