TAP 8T2726 - Caterpillar

start by:a) disassemble brakes1. Remove oil line between anchor housing and spindle.2. Fasten a hoist and tool (A) to the anchor housing and spindle. 3. Remove nuts and lockwashers from spindle studs. Remove anchor housing (1) and spindle as a unit. Weight is 620 lb. (281 kg). Remove O-ring seal from spindle.4. Put the spindle on a block and remove the four bolts that hold anchor housing and spindle together. 5. Install three 1/2"-13NC forged eyebolts (2) in anchor housing. Fasten a hoist and remove anchor housing. Weight is 300 lb. (136 kg).Install Anchor Housings And Spindles
1. Install O-ring seal (1) on spindle. Fasten a hoist and put anchor housing in position on spindle. 2. Install the four bolts (3) to hold the spindle and anchor housing together.3. Fasten a hoist and tool (A) to the anchor housing and spindle. Install O-ring seal (2) on spindle.4. Put spindle in position on axle housing and install nuts and lockwashers. Tighten nuts to a torque of 640 80 lb.ft. (88.5 11.1 mkg).5. Install oil line between anchor housing and spindle.end by:a) assemble brakes