TEE AS 1962036 - Caterpillar

(31)Transmission
Hot oil and components can cause injury. Do not allow hot oil or components to contact the skin.
The machine must be level and the oil warm. Lower the bucket with slight down pressure. Apply the parking brake. Stop the engine. 1. Remove the transmission drain plug and drain the oil. 2. Change the filter element. See the topic "Transmission" under "Every 500 Service Hours or 3 Months." 3. Remove the magnetic strainer cover. 4. Remove the retainer, the tube and the screen from the housing.
When using pressure air, wear a protective face shield and protective clothing. The maximum air pressure must be below 205 kPa (30 psi) for cleaning purposes.Use all cleaning solutions with care.
Do not drop or rap the magnets against any hard objects. Replace any damaged magnets.
5. Remove the tube and magnets from the screen. 6. Wash the tube and the screen in a clean, nonflammable solvent. 7. Clean the magnets with a cloth, a stiff bristle brush or pressure air. 8. Clean the cover and inspect the seal. Replace the seal, if it is damaged. 9. Insert the tube and magnets in the screen. 10. Insert the screen, tube and magnets in the housing. 11. Install the cover. Tighten the cover bolts. 12. Clean and install the transmission drain plug. Fill the transmission with oil. See the "Refill Capacities" chart under "Fuel, Coolant, and Lubricant Specifications." 13. Remove the transmission breather. Install a new breather. 14. Start the engine. Apply the service brake. Depress the right brake pedal only. 15. Slowly operate the transmission controls to circulate the oil. Lock the transmission control in NEUTRAL. 16. Inspect for leaks. Measure the oil level. 17. Maintain the oil level between the FULL and ADD OIL mark on the ENGINE RUNNING side of the dipstick. 18. Add oil if necessary.19. Stop the engine.(32)Drive Shaft Support Bearing
The lube fitting for the drive shaft support bearing is mounted on the right hand side of the front loader frame. Lubricate 1 fitting.(33)Drive Shaft Universal Joints
1. Lubricate 1 fitting in the front shaft universal joint. 2. Lubricate 1 fitting in the front universal joint of the center shaft. 3. Lubricate 1 fitting in the rear universal joint of the center shaft. 4. Lubricate 1 fitting in each of the two rear shaft universal joints. Total 5 fittings.(34)Frame Upper and Lower Pivot Bearings
1. Lubricate 1 fitting at the upper pivot pin. 2. Lubricate 1 fitting at the lower pivot pin. Total 2 fittings.(35)ROPS (Rollover Protective Structure)
To avoid possible weakening of the ROPS (Rollover Protective Structure), consult a Caterpillar dealer before altering the ROPS in any way. The protection offered by the ROPS will be reduced if it has been subjected to structural damage or has been involved in an overturn incident.
1. Inspect the ROPS structure. 2. Tighten the 6 mounting bolts on each side of the machine to 570 80 N m (420 60 lb ft).