TEE 2P1298 - Caterpillar

Entering the Blade Wear
The height of the blade is measured from the center of the retaining bolts to the cutting edge. If the blade wear is uneven, use an average value. However, guidance will never be better than the range of the differences.In order to set the Blade Wear height, complete the following steps:
Illustration 1 g01109185
Measure the cutting edge height to the center of the bolt holes. Refer to Illustration 1.
Illustration 2 g01458392
From the "Setup Menu – Configuration" dialog, select the "Blade Wear" option. Refer to Illustration 2.
Press the "OK" button.A screen that is similar to Illustration 3 will open.
Illustration 3 g01300202
Note: Be aware of the units. If the display is set up in metric units, the blade measurement must be entered in metric. If the display is set up in feet, the blade measurement must be entered in tenths of feet.
Use the arrow keys in order to enter a value into the "Cutting Edge Height" field.
Perform one of the following actions:
Press the "OK" key in order to accept the changes and return to the "Setup Menu – Configuration" dialog.
Press the "ESC" key in order to cancel any changes and return to the "Setup Menu – Configuration" dialog. You are asked to confirm that you do not want to save any changes.
Press the "ESC" key in order to exit the "Setup Menu – Configuration" dialog. The changes take effect immediately.