TEE 5G2740 - Caterpillar

5G2740 TEE Caterpillar parts 910, 966F II, IT12

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA5G2740
5G-2740
5G2740

Weight: 0.60 pounds 0 kg.

Buy TEE 5G2740 Caterpillar genuine, new aftermarket tractor parts with delivery
COMPACT WHEEL LOADER, WHEEL LOADER,

Compatible equipment models: 5G2740:

COMPACT WHEEL LOADER 910

INTEGRATED TOOLCARRIER IT12

WHEEL LOADER 966F II Caterpillar

Number on catalog scheme: 5

For full view, you need register

Information:

START BY: a. remove flywheelb. remove oil pan 1. Remove the starter from the engine.2. Fasten tooling (A) and a hoist to the flywheel housing as shown.
Be careful not to damage the crankshaft rear seal when flywheel housing (1) is removed.
3. Remove bolts (2) and the washers that hold the flywheel housing to the cylinder block.4. Remove flywheel housing (1) and the gasket. The weight of the flywheel housing is 39 kg (85 lb.).Install Flywheel Housing
1. Clean the old gasket from the surfaces of the cylinder block and flywheel housing that make contact with each other. Install a new gasket on the cylinder block. 2. Install two 7/16"-14 NC × 7 in. (178 mm) long guide bolts (1) in the cylinder block as shown.3. Put clean engine oil on the crankshaft rear wear sleeve and on the lip of the seal.
Be careful not to damage the crankshaft rear seal when flywheel housing (2) is installed.
4. Fasten tooling (A) and a hoist to flywheel housing (2) as shown. Put the flywheel housing in position on the cylinder block, and install the bolts that hold it. Tighten the bolts to a torque of 90 15 N m (65 11 lb.ft.).5. Cut the bottom of the gasket even with the flywheel housing and cylinder block. Put 5H2471 Gasket Cement on the bottom of the gasket where the gasket makes contact with the oil pan gasket.6. Install the starter on the engine.END BY: a. install oil panb. install flywheel